If your cardstock is not already folded, trim to a 5" x 7" rectangle and fold in half to create a 3.5" x 5" folded card (or use pre-cut 5" x 7" folded). Make sure edges are even by using a ruler and paper trimmer or scissors.

Prepare printed insert

Trim the printed gift card insert to fit the inside of the card. Typical insert size is slightly smaller than the card interior (for a 5" x 7" card, trim insert to about 4.75" x 6.75"). Align the insert so margins are even.

Attach adhesive to gift card

Attach two small pieces of double-sided tape or two adhesive foam squares to the back of the gift card—one near the top edge and one near the bottom edge. If you want a removable option, use low-tack adhesive or a small envelope pocket instead.

Position gift card on insert

Place the insert face-down. Measure and mark the desired location of the gift card (commonly centered horizontally and positioned in the lower half of the insert). Use a ruler or lightly mark with the pen if helpful.

Affix gift card to insert

Remove the backing from the tape/foam and carefully press the gift card onto the insert at the marked position. Press firmly for 10–15 seconds to ensure good adhesion. If using foam squares, this will give a slight raised effect.

Write or personalize message

Open the card and place the insert with the attached gift card inside. Use the pen to write a personalized message on the insert or on the card interior. Double-check spelling and amount details if handwritten.

Secure the insert inside the card

Use two small pieces of double-sided tape at the top edge of the insert to attach it to the card interior so it doesn't shift. Alternatively, apply a thin line of adhesive along the back top edge only to allow the bottom to lift slightly when removing the gift card.

Add finishing touches

If using ribbon or twine, wrap it around the closed card and tie a small bow. Place the card into the matching envelope. Add a decorative sticker seal on the envelope flap or card exterior for a polished look.

Final check

Confirm the gift card is secure but accessible, the insert is straight, the message is legible, and the envelope is sealed. If mailing, include any activation receipt or important instructions inside or attached.